[mrtg] Re: graphing in and out octets

[Sander Foppen]

Hi Makai,

It works allright when I use instance numbers. But I don't want to use
the numbers but the description to identify the interfaces because of
the index shifting when I ad or remove an interface.

So instead of:
Target[NVB-C1603-HRV-001_Serial0_Octets]:
1.3.6.1.2.1.2.2.1.10.5&1.3.6.1.2.1.2.2.1.16.5:NVB514 at 192.168.101.5:

With the interface number 5, I want to use the description "\Serial0"

Gr,
  Sander Foppen

-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch]
On Behalf Of Makai Jozsef
Sent: donderdag 23 januari 2003 17:34
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Re: graphing in and out octets



Hi Sander,

You need an instance number at the end of the OID....

But first try to use the cfgmaker.

Then test the mrtg without rrd.

Jozsef


> Hello,
> 
> I want to graph traffic by using het OID for IfInOctets en 
> IfOutOctets.
> By my knowledge these are:
> 
> IfInOctets : 1.3.6.1.2.1.2.2.1.10
> IfOutOctets : 1.3.6.1.2.1.2.2.1.16
> 
> And this is my cfg-file: 




 
> The problem I see is that when I start the MRTG deamon, it runs for a
> couple of seconds and then stops. When I look in my data directory I
> don't see any files created. There also are no error messages.
> 
> What am I doing wrong?
> 
> Gr,
>   Sander Foppen

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi