[mrtg] Re: Incorrect Low value graph

[Rikunj]

Thankyou BOB & all.

The problem was resolve.

Regards,
Rikunj

----- Original Message -----
From: "Bob Love" <bob.lists at boblove.org>
To: <mrtg at list.ee.ethz.ch>
Sent: Sunday, November 02, 2003 1:31 AM
Subject: [mrtg] Re: Incorrect Low value graph


> > I am expecting much higher values on graphs.
> > This Interface is supposed to flow at the rate of 1.5 Mb the graphs
shows
> > 300 kb.
>
> > MaxBytes[CISCO]: 150000
>
> 150000 is too low for an interface with a T1 on it - remember you divide
by
> 8 not 10.
>
> T1 = 1544000 = MaxBytes 193000
>
> It doesn't hurt to leave a little room in MaxBytes especially a link that
> peaks frequently. I'd use 200000 for this if I were you.
>
> MaxBytes is only used, to ignore "glitches" - i.e. make sure you don't get
> any 8mbps glitches on a T1 due to an erroneous reading. You don't need to
> (or shouldn't, in my experience) set it to *exactly* the maximum you
> expect - a little headroom doesn't hurt.
>
> Regards
>
> Bob
>
>
> --
> Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
> Archive     http://www.ee.ethz.ch/~slist/mrtg
> FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
> WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi
>
>


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi