[mrtg] Monitoring McData SAN Switch

[Eric Brander]

Well I found a McData mib and found the 64-bit counter for the
interfaces.  However when I get/walk the interfaces I get hex numbers.
If I use the 32-bit counters then I get base-10 numbers, but on 2-gig
SAN interfaces the 32-bit counters are useless.  Is there a way in MRTG
to convert the hex to decimal on the Target line?

Here is an example of an SNMPWALK:

.iso.3.6.1.4.1.289.2.1.1.2.3.1.1.81.11 =  Hex: 00 00 02 45 CC 11 F0 D0
.iso.3.6.1.4.1.289.2.1.1.2.3.1.1.81.12 =  Hex: 00 00 00 15 B8 AF 96 00
.iso.3.6.1.4.1.289.2.1.1.2.3.1.1.81.13 =  Hex: 00 00 00 06 A4 E4 21 E4
.iso.3.6.1.4.1.289.2.1.1.2.3.1.1.81.14 =  Hex: 00 00 00 9A 8A E1 8F 60
.iso.3.6.1.4.1.289.2.1.1.2.3.1.1.81.15 =  Hex: 00 00 00 00 1B 8F 2F 2C
.iso.3.6.1.4.1.289.2.1.1.2.3.1.1.81.16 =  Hex: 00 00 00 4D D7 C2 20 6C
.iso.3.6.1.4.1.289.2.1.1.2.3.1.1.81.17 =  Hex: 00 00 00 00 16 DE 7F 5C

TIA,

Eric Brander
Eric_Mailing_List at rednarb dot com

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi