[mrtg] Re: Calling MIBs

[McDonald, Dan]

 >Barakat, Mehmet-Hasan

>WorkDir: /www/htdocs/pxtl/
>Options[_]: growright

Ok, there is growright...  But you don't define gauge, which you need for a
value that is not monotonically increasing....  You probably want to add
that as:
Options[temp]: growright, gauge

>LoadMIBs: /www/htdocs/pxtl/Sentry3.mib

>Target[temp1]:
.1.3.6.1.4.1.1718.3.2.5.1.6&.1.3.6.1.4.1.1718.3.2.5.1.6:public at 10.6.16.x
yz
the leading . on the OID should be removed.  Alternatively, use the oid name
from the mib, assuming you have listed all of the mibs on any IMPORTS line
in the MIB file.

Make certain there is not an instance that has to be appended to the OID -
for some devices you may need to add .0  My temperature probes support up to
8 temperature sensors, so I run a configure template that walks the OID and
creates temperature entries for each of the points.

>YLegend[temp1]: Temperature
>Legend1[temp1]: Temperature
>LegendI[temp1]:
>LegendO[temp1]:
>MaxBytes[temp1]: 100

You might want to make that a little higher.  The maximum temperature for
many electronic devices is 158F, so that's what I usually set maxbytes (or
at least absmax) to.  I do have one camera outdoor in a glass dome that
regualrly gets up to 135F...

>Title[temp1]: Temp Analysis -- Sentry3_100866
>PageTop[temp1]: <H1>Temp Analysis -- Sentry3_100866</H1>

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi