[mrtg] Re: routers2.cgi problem

[Jon]

Thanks Steve,

That help a lot, my problem was fixed and everything is a go!

Thanks again,

Jon

-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch] On
Behalf Of s.shipway at auckland.ac.nz
Sent: Friday, April 09, 2004 5:55 PM
To: Jon Ha
Cc: mrtg
Subject: [mrtg] Re: routers2.cgi problem

Quoting Jon Ha <Jon at mail.xanga.net>:
> great there but when I tried to mimic the exact same setup on a Windows
2000
> Server I am unable to generate any graphs with routers2.  I notice the
graphs
There is a separate mailing list and discussion forum for routers2.cgi 
problems, see the pages on http://www.steveshipway.org/software/

It sounds as if you have your iconurl, graphpath, graphurl settings
incorrect 
in your routers2,conf file, or maybe incorrect permissions on the graphpath 
folder.  If you go to the configuration verification page
http://yourserver/cgi-bin/routers2.pl?page=verify then it will test for many

common errors.  

Steve

-------------------------------------------------
This mail sent through University of Auckland
http://www.auckland.ac.nz/


-- Binary/unsupported file stripped by Ecartis --
-- Err : No filename to use for decode, file stripped.
-- Type: application/pgp-keys
-- Desc: PGP Public Key


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi