[mrtg] Re: unable to poll

[jon.hartman at verizon.com]

I ran into the same thing. I upgraded the backend to rrdtool and dropped
my polling interval to 1 minute to get around the issue. Bear in mind,
that you can't utilize any lower polling frequency than 5 minutes, if you
are just using MRTG. You need to use RRDtool on the backend to use the
1-minute interval.

-Jon Hartman

-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch] On
Behalf Of Vishal B Patel
Sent: Thursday, June 17, 2004 3:00 AM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] unable to poll


 dear all ,

 We  have  shifted  one of our links from ethernet to  fiber on a cisco
7500 router.

The  traffic  goes above 120 Mpbs now ..and  my  mrtg  is not able to read
that..., i get  blank spaces in the graph  or sometimes  it only  10 % of
the real utilization.

Does MTRG has  problem reading such  high traffic , i read  on the  site
below :

http://faq.mrtg.org/FAQ004.html

can anyone  comment on this.

Please  also tell me  how  to reduce the time of the counters from 5 mins
to 1 min.

Thanks a lot

Vishal 

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi