[mrtg] Re: can't get traffice from sub-interface of router

[Pavel Ruzicka]

Hello,

> hello,guys. I have run mrtg2.10 successfully recently. Now it can monitor
> the traffic of ATM aal5 layer, but can't get the value of ATM subinf &
> gigaethernet's subif. the gigaethernet port has been configured as 802.1q
> trunk.
> Why mrtg can generate the conf of subif,but can't get the data from those
> subifs? plz help me.

Probably there is problem on device. Some Cisco routers with older IOSes have
this problem. For measuring hispeed interfaces (more than 100Mbps) is better
to enable SNMPv2, due to 64bit counters.

Best regards,

Pavel Ruzicka 

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi