[mrtg] Re: How to measure Network Utilisation Percentage in MRTG

[Meng Keng Lee]

Yes, I did.
Eric Brander <Eric_Mailing_List at rednarb.com> wrote:Meng Keng Lee wrote:

> Hello,
> To see what value it will produce I set the ThreshMaxO[A2RT01.Fa4_0_0.load]:0% and run a perl script to show the current parameter value.
> 
> But the value I get is 26052.2781666667 and 5179.73132222222. Both value are definitely not below 100%
> 
> Any help on this?
> 

Have you set a Threshdir global setting? I think it may be required. 
That's the folder where a file will be created when a threshold is 
crossed. The next time MRTG runs and it sees that a threshold is crossed 
again, it first checks in that folder to see if it was crossed already 
and if so it skips running the ThreshProgx[] script.

HTH,

Eric Brander

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive http://www.ee.ethz.ch/~slist/mrtg
FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi

Homepage http://www.mrtg.org
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi



		
---------------------------------
Do you Yahoo!?
New and Improved Yahoo! Mail - 100MB free storage!

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi