[mrtg] Re: T1 Frame Relay Traffic

[Masood Ahmad Shah]

you can put all your interface in single Target like

Target[T1]: oid:comm..ty at routerip+oid:comm.ty at routerip+.............s

Best Regds,
Masood Ahmad Shah
Nexlinx
http://nexlinx.net.pk


----- Original Message ----- 
From: "Carlos Welhous, TRI" <CWelhous at tricom.com.do>
To: "MRTG Mailing List" <mrtg at list.ee.ethz.ch>
Sent: Wednesday, March 24, 2004 7:23 PM
Subject: [mrtg] T1 Frame Relay Traffic


> Hi all,
> Please check this environment. A router Cisco 7513 with a DS3 (T3)
> controller. One of its interfaces created is a T1 frame relay.
> I can obtain with MRTG (2.9.17) the traffic of any frame relay
> sub-interface, but not the entire T1.
> I'm interested to know if it is possible to obtain traffic statistics of
the
> complete T1 frame relay using MRTG.
>
> Thanks in advanced,
>
> Regards,
>
> Carlos Welhous
> Network Engineer
> 1(809)334-7180
> www.tricom.net
> Dominican Republic
>
> --
> Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
> Archive     http://www.ee.ethz.ch/~slist/mrtg
> FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
> WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi
>

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi