[mrtg] Question regarding Serial interface on 3725/DS3

[Tim Reimers]

I've got a 6MB DS3 on a Cisco 3725, and some of the values I've been
getting back
don't look right-

Here's what's at the bottom of the graph-

"Max  In: 100.1 kB/s (1.8%)   Average  In: 9202.0 B/s (0.2%)   Current
In: 42.4 kB/s (0.8%)  
Max  Out: 26.0 kB/s (0.5%)   Average  Out: 3040.0 B/s (0.1%)   Current
Out: 8115.0 B/s (0.1%)"  


I'm not sure why the average in is 9202K- is this 9.2 megs? (maybe I
just haven't had enough coffee yet)


The 5526.2 isn't right- but it's higher- the actual bandwidth available
top end
configured on the router is the ' dsu bandwidth 44210' that Bell South
had me put in-

They control the speed down to 6 MB on their end to meet our SLA.


Here's the relevant section of the config: built by cfgmaker
### Interface 5 >> Descr: 'Serial1/0' | Name: 'Se1/0' | Ip:
'68.152.xxx.54' | Eth: '' ###

Target[xxx.xxx.83.253_Serial1_0]: \Serial1/0:xxxx at Xxxxxxx:
SetEnv[xxx.xxx.83.253_Serial1_0]: MRTG_INT_IP="68.152.158.54"
MRTG_INT_DESCR="Serial1/0"
MaxBytes[xxx.xxx.83.253_Serial1_0]: 5526250
Title[xxx.xxx.83.253_Serial1_0]: Serial1/0 -- acsbr3725
PageTop[xxx.xxx.83.253_Serial1_0]: <H1>Serial1/0 -- acsbr3725</H1>
 <TABLE>
   <TR><TD>System:</TD>     <TD>acsbr3725 in </TD></TR>
   <TR><TD>Maintainer:</TD> <TD></TD></TR>
   <TR><TD>Description:</TD><TD>Serial1/0  </TD></TR>
   <TR><TD>ifType:</TD>     <TD>frame-relay (32)</TD></TR>
   <TR><TD>ifName:</TD>     <TD>Se1/0</TD></TR>
   <TR><TD>Max Speed:</TD>  <TD>5526.2 kBytes/s</TD></TR>
   <TR><TD>Ip:</TD>         <TD>xxx.xxx.158.54 ()</TD></TR> 
 </TABLE>  



Tim Reimers
Asheville City Schools IT
tim.reimers(at)asheville(dot)k12(dot)nc(dot)us
828-255-5304x374
 


http://www.gordano.com - Messaging for educators.

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi