[mrtg] Re: mrtg and CIPE

[William Owen]

Even if the interface is detected as operationally down, it should be added
to the config file.  You can edit the config and un-comment (remove the #'s)
the entries that you want.  You'll probably have to enter a sensible
maxbytes[target]: for each entry though because is will probably read 0
meaning that no data will be logged.

-----Original Message-----
From: Michael Nuss [mailto:nmx at fromtheshadows.net] 
Sent: Friday, September 10, 2004 1:03 PM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] mrtg and CIPE

Has anyone had any luck using mrtg to monitor traffic over CIPE 
tunnels?  I'm using Linux boxes as the endpoints, running snmpd.  When I 
run cfgmaker, it detects the active tunnels but reports that they are 
operationally down and have a speed of zero. I'm not too experienced 
with snmp (or mrtg for that matter) so I can't figure out what to do. 
I'm not having any trouble monitoring the standard Ethernet interfaces.

Thanks in advance,
Mike Nuss

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi