[mrtg] Re: Unit Scale Incorrect for Juniper rtr interfaces

[Smith, H.Michael]

OK... before I get any well deserved "RTFM"s.... I did and found the
answer:

Options[_]: growright, bits

Thank you to those who would have responded, had I not have found this.
:-)


-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch]
On Behalf Of Smith, H.Michael
Sent: Saturday, November 19, 2005 11:20 PM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Unit Scale Incorrect for Juniper rtr interfaces

I'm running mrtg-2.9.16 on windows, monitoring three interfaces on a
Juniper m7i JUNOS 6.2.

The utilization reported by mrtg is incorrect.  It some cases, it
appears to be ~1/10 the actual utilization. (i.e. show int reports
~27Mbps and mrtg reports ~2.7Mbps) In other cases, the discrepancy is
not so neat.  The numbers reported by mrtg are always significantly less
than they should be. 

Has anyone seen this / is aware of a resolution?

Thanks,
Michael

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://lists.ee.ethz.ch/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://lists.ee.ethz.ch/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://lists.ee.ethz.ch/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://lists.ee.ethz.ch/lsg2.cgi