[mrtg] Re: Problems with interfaces sum graphic

[NAP]

Hi,
I'm so glad because i probed the solution you suggested, and it's working very well.

Thanks a lot,

Regards,

NAP
  ----- Original Message ----- 
  From: Syed Waqqas Ahmed 
  To: NAP 
  Sent: Thursday, October 26, 2006 11:55 AM
  Subject: Re: [mrtg] Problems with interfaces sum graphic


  hi,

  This is quite common issue if the traffic values are increasing 100 Mbps you starting to get no value when values increases from 100 Mbps , in single interface of over 100 Mbps monitoring we usually add :::::2 in the end of target 

  example : 

  Target[ANY]:  <index>:<community>@<ip address>:::::2

  In monitoring multiple interface i guess u have add this in the end of all ... but i m not sure i havent tried it on multiple/aggregated mrtgs... 

  Thats all i know...Hope it solves the problem...

  Regards

  Waqqas 

  NAP <nap at etecsa.cu> wrote:
    Hello All,
    I am monitoring several interfaces, each one in an independent way, obtaining graphics with the real result, but while adding this interfaces and its total value been higher than 100 Mb/s, the graffic behaves in an intermittent way.

    I thank some suggestion

    Best regards,





    --
    Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
    Archive http://lists.ee.ethz.ch/mrtg
    FAQ http://faq.mrtg.org Homepage http://www.mrtg.org
    WebAdmin http://lists.ee.ethz.ch/lsg2.cgi




  Send instant messages to your online friends http://uk.messenger.yahoo.com 

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://lists.ee.ethz.ch/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://lists.ee.ethz.ch/lsg2.cgi