[mrtg] Re: Problems with interfaces sum graphic

[NAP]

hi,
this happened to me, and the solution to this problem comes explained down,

hope you solves too,

Regards,

nap
  ----- Original Message ----- 
  From: Syed Waqqas Ahmed 
  To: NAP 
  Sent: Thursday, October 26, 2006 11:55 AM
  Subject: Re: [mrtg] Problems with interfaces sum graphic


  hi,

  This is quite common issue if the traffic values are increasing 100 Mbps you starting to get no value when values increases from 100 Mbps , in single interface of over 100 Mbps monitoring we usually add :::::2 in the end of target 

  example : 

  Target[ANY]:  <index>:<community>@<ip address>:::::2

  In monitoring multiple interface i guess u have add this in the end of all ... but i m not sure i havent tried it on multiple/aggregated mrtgs... 

  Thats all i know...Hope it solves the problem...

  Regards

  Waqqas 


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://lists.ee.ethz.ch/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://lists.ee.ethz.ch/lsg2.cgi