[mrtg] Re: Cisco 7206 and POS Interfaces

[Meurer, Jason]

I've seen the same with all of ATM interfaces.  They report as valid as
they do handle ATM specific information but do not actually handle data.
I ended up just commenting them out in the cfg files. 

-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch]
On Behalf Of Martin Rheumer
Sent: Wednesday, October 18, 2006 5:17 AM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Cisco 7206 and POS Interfaces


Gday,

We have been trying to run cfgmaker on a cisco 7206 with an ATM / POS
interface and always blamed the older versions of cfgmaker finding lots
of interfaces. We have finally upgraded and its still finding "extra"
interfaces. In particular these are ATM1/0-atm-layer interfaces. But
when we poll them there is no In and Out octets for these. Has anyone
else seen these and have a way around this ?

Thanks
Martin


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://lists.ee.ethz.ch/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://lists.ee.ethz.ch/lsg2.cgi

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://lists.ee.ethz.ch/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://lists.ee.ethz.ch/lsg2.cgi