[mrtg] MRTG Brocade switch monitoring error

[Matthew Petach]

The crucial line is
WARNING: Skipping host fcswitch as it does not resolve to an IPv4 address

Make sure that the name you put in your config file is the right
name for the device; if you can't ping it by that name, MRTG can't
do anything as far as monitoring it.

Matt




----- Original Message ----
From: anjini shukla <anjinishukla at gmail.com>
To: mrtg at lists.oetiker.ch
Sent: Tuesday, August 26, 2008 4:56:12 PM
Subject: [mrtg] MRTG Brocade switch monitoring error


Hello, 
I am trying to plot graphs for my Brocade 4100 SAN switch and am using 
Solaris 10, I am following the documentation given: http://www.xolution.ch/mrtg/   i have written my config file: 

~ snip 
Target[switch.IP_0]: 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.12.1&1.3.6.1.4.1.1588.2.1.1.1.6.2.1.11.1:public at fcswitch 
Title[switch.IP_0]: fc throughput on switch fcswitch port 0 (mysun jnic0 slot7) 
PageTop[switch.IP_0]: <H1>fc throughput on switch fcswswitch port 0 (mysun jnic0 slot7)</H1> 

~snip 

the error message i am getting is: 

2008-08-26 12:03:22: WARNING: Skipping host fcswitch as it does not resolve to an IPv4 address 
2008-08-26 12:03:22: WARNING: no data for 1.3.6.1.4.1.1588.2.1.1.1.6.2.1.12&1.3.6.1.4.1.1588.2.1.1.1.6.2.1.11:public at fcswitch. 
Skipping further queries for Host fcswitch in this round. 
2008-08-26 12:03:22: ERROR: Target[xxx.xxx.xxx.xx_0][_IN_] ' $target->[0]{$mode} ' did not eval into defined data 
2008-08-26 12:03:22: ERROR: Target[xxx.xxx.xxx.xx_0][_OUT_] ' $target->[0]{$mode} ' did not eval into defined data 

can any one give me any insight on this, ?? 
Thanks


      
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.oetiker.ch/pipermail/mrtg/attachments/20080827/15d818f0/attachment.html