[mrtg] Can Not determine if Number problem

[Mersberger, Robert]

 What and where is the mrtg.old file that you are talking about. I know
that the Interface exist so your first suggestion in what I would like
to try.


-----Original Message-----
From: mrtg-bounces at lists.oetiker.ch
[mailto:mrtg-bounces at lists.oetiker.ch] On Behalf Of McDonald, Dan
Sent: Monday, September 29, 2008 2:00 PM
To: mrtg at lists.oetiker.ch
Subject: Re: [mrtg] Can Not determine if Number problem

On Mon, 2008-09-29 at 13:11 -0500, Mersberger, Robert wrote:
> I need your assistance.
> 
> I am getting the following error and have not been able to determine 
> or correct this issue.
> 08-09-29 12:55:08: WARNING: Can not determine ifNumber for
> da1sy at 10.5.37.254:::::1      ref: 'Name'     key: 'Se0/0/0.700'
> 
> I have rerun the cfgmaker for this device, I have rebooted this device

> and ran the cfgmaker again.  This is one of 6 interfaces on this 
> device and all others are reporting fine. I have also checked and 
> rechecked the community name.
> 

Sometimes the mrtg.old file gets corrupted.  Try deleting that.

If that doesn't fix it, then do an snmpwalk on ifName to make certain
that Se0/0/0.700 shows up.




--
Daniel J McDonald, CCIE #2495, CISSP #78281, CNX Austin Energy
http://www.austinenergy.com



Please consider the environment before printing this e-mail.

CONFIDENTIAL NOTICE:
This e-mail message and any attachment(s) (collectively, this 'Email') are intended
only for the confidential use of the recipient(s) named above. If the reader of this
message is not the intended recipient named above or an agent responsible for
delivering it to the intended recipient named above, you have received this Email in error.
Please notify the sender immediately and permanently delete this Email and any copies thereof.