[smokeping-users] Re: HELP - SMOKEPING.CGI ERROR

[Brett Marler]

> I installed it using the RedHat-7.3-SpeedyCGI-2.21.rpm, however I am
> running Redhat8.0 could it be that??
If I was you, I'd grab the tar.gz from "http://daemoninc.com/speedycgi/" and 
install from there. There may be differences in Redhat packages from 7.3 to 
8.0. I am running 7.2 here with SpeedyCGI installed from the tar.gz and it 
works a treat.

Missing the ".packlist" file should not cause it to not work as the contents 
of it simply state where the 2 executables are installed and where the .pm 
perl module resides.

Try installing from the source and you should be sorted out. It's pretty 
straight forward to install, from memory its just "./configure ; make ; make 
install".


Regards.
-- 
Brett Marler <brett at asroma.homeip.net>
WWW:	http://asroma.homeip.net/




-- Binary/unsupported file stripped by Ecartis --
-- Err : No filename to use for decode, file stripped.
-- Type: application/pgp-signature


--
Unsubscribe mailto:smokeping-users-request at list.ee.ethz.ch?subject=unsubscribe
Help        mailto:smokeping-users-request at list.ee.ethz.ch?subject=help
Archive     http://www.ee.ethz.ch/~slist/smokeping-users
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi