[smokeping-users] Re: HELP - SMOKEPING.CGI ERROR

[Mukesh Bavisi]

I have just tried that, it give me even more error they all like to be
with speedy. What is the best way to uninstall and then do a clean
install??

Cheers

Muk

-----Original Message-----
From: smokeping-users-bounce at list.ee.ethz.ch
[mailto:smokeping-users-bounce at list.ee.ethz.ch] On Behalf Of Brett
Marler
Sent: 03 February 2003 14:41
To: Mukesh Bavisi
Cc: smokeping-users at list.ee.ethz.ch
Subject: [smokeping-users] Re: HELP - SMOKEPING.CGI ERROR 


> I installed it using the RedHat-7.3-SpeedyCGI-2.21.rpm, however I am
> running Redhat8.0 could it be that??
If I was you, I'd grab the tar.gz from "http://daemoninc.com/speedycgi/"
and 
install from there. There may be differences in Redhat packages from 7.3
to 
8.0. I am running 7.2 here with SpeedyCGI installed from the tar.gz and
it 
works a treat.

Missing the ".packlist" file should not cause it to not work as the
contents 
of it simply state where the 2 executables are installed and where the
.pm 
perl module resides.

Try installing from the source and you should be sorted out. It's pretty

straight forward to install, from memory its just "./configure ; make ;
make 
install".


Regards.
-- 
Brett Marler <brett at asroma.homeip.net>
WWW:	http://asroma.homeip.net/




-- Binary/unsupported file stripped by Ecartis --
-- Err : No filename to use for decode, file stripped.
-- Type: application/pgp-signature


--
Unsubscribe
mailto:smokeping-users-request at list.ee.ethz.ch?subject=unsubscribe
Help        mailto:smokeping-users-request at list.ee.ethz.ch?subject=help
Archive     http://www.ee.ethz.ch/~slist/smokeping-users
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

--
Unsubscribe mailto:smokeping-users-request at list.ee.ethz.ch?subject=unsubscribe
Help        mailto:smokeping-users-request at list.ee.ethz.ch?subject=help
Archive     http://www.ee.ethz.ch/~slist/smokeping-users
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi