[mrtg] Mrtg Cisco Voice QUESTIONS

[Pentony, Alan]

						Greetings

Has anybody got Mrtg working with Voice cards yet? 
Im thinking more 4W&M and 2 Wire as opposed to T1 or E1 and more of how many
calls not so much utilisation.

Also the dial Peer information see below

Ive had a look at Cisco's Voice MIB but no success in identifying a oid for
number of call's however the number of calls are available from the Console
by typing sh dial-peer voice  

indexmaker see's them but gets confused as to what they are (SEE BOTTOM OF
EMAIL).

Ive walked the MIB but no success

Anybody out there trying to do the same thing and been successful


VoiceEncapPeer1
        tag = 1, destination-pattern = `+22',
        answer-address = `',
        group = 1, Admin state is up, Operation state is up
        type = pots, prefix = `',
        session-target = `', voice-port = 1/0/0
        Connect Time = 493192, Charged Units = 0
        Successful Calls = 22, Failed Calls = 20
        Accepted Calls = 42, Refused Calls = 0
        Last Disconnect Cause is "10  "
        Last Disconnect Text is "normal call clearing."
        Last Setup Time = 23149376
VoiceOverIpPeer25
        tag = 25, destination-pattern = `+25',
        answer-address = `',
        group = 25, Admin state is up, Operation state is up
        type = voip, session-target = `ipv4:10.4.0.1',
        ip precedence: 0        UDP checksum = disabled
        session-protocol = cisco, req-qos = guaranteed-delay,
        acc-qos = best-effort,
        fax-rate = voice, codec = g729r8,
        Expect factor = 10, Icpif = 30,
        VAD = enabled, Poor QOV Trap = disabled
        Connect Time = 35768515, Charged Units = 0
        Successful Calls = 2619, Failed Calls = 0
        Accepted Calls = 2619, Refused Calls = 0
        Last Disconnect Cause is "10  "
        Last Disconnect Text is "normal call clearing."
        Last Setup Time = 1070274160                       


#---------------------------------------------------------------
########
######## This Interface is one of the following
######## - administratively not UP
######## - it is in test mode
######## - it is a softwareLoopback interface
######## - has a unrealistic speed setting
######## It is commented out for this reason.
########
# 
# Target[134.211.176.53.7]: 7:public at 134.211.176.53
# MaxBytes[134.211.176.53.7]: 0
# Title[134.211.176.53.7]: Router (): Foreign Exchange Office (FXO-M6) 1/0/0
# PageTop[134.211.176.53.7]: <H1>Traffic Analysis for Foreign Exchange
Office (FXO-M6) 1/0/0
#  <BR></H1>
#  <TABLE>
#    <TR><TD>System:</TD><TD>Router in </TD></TR>
#    <TR><TD>Maintainer:</TD><TD></TD></TR>
#    <TR><TD>Interface:</TD><TD>Foreign Exchange Office (FXO-M6) 1/0/0
(7)</TD></TR>
#    <TR><TD>IP:</TD><TD> ()</TD></TR>
#    <TR><TD>Max Speed:</TD>
#        <TD>0.0 Bytes/s (Voice Foreign eXchange Office
(voiceFXO))</TD></TR>
#   </TABLE>
# 
#---------------------------------------------------------------
########



Alan Pentony
Principal Data Consultant
CCIE 2846
Wang Global
2 Minna Place
Belrose NSW 2085
Direct  +61 (0)2 98986330
Fax     +61 (0)2 98986357
Mobile  +61 (0)418628764
Email : apentony at usa.net 

--
* To unsubscribe from the mrtg mailing list, send a message with the
  subject: unsubscribe to mrtg-request at list.ee.ethz.ch
* The mailing list archive is at http://www.ee.ethz.ch/~slist/mrtg