[mrtg] Re: New Install on Linux

David E. Mazza dmazza at adt.com
Wed Oct 27 15:05:30 MEST 1999


Thanks for the response Neil!

The data seems to be inacurate, the only variance is at the tail end of a
trace, not a clean drop, a stagered drop.

BTW, these are Cicso 2524's, all with frame, some T1 and some 56k.

-----Original Message-----
From: Neil Calvert [mailto:ncalvert at cabletron.com]
Sent: Tuesday, October 26, 1999 5:27 PM
To: David E. Mazza; Mrtg List
Subject: Re: [mrtg] New Install on Linux


I guess what I'd be asking is, is the data correct? You say 'little or
no variance'. If they were all identical then that may be a problem. But
small differences means things are probably ok.

Do you have any way of querying these devices besides MRTG to verify
that you are getting good or bad data? Try using a different package to
browse your device mibs to see what the device is saying. (On linux, you
should be able to run 'snmpwalk' from the command line to peer at
different OIDs. If you prefer a GUI, one that many of us use is GetIf :
http://www.geocities.com/SiliconValley/Hills/8260/)  If the numbers are
out of whack with what MRTG is reporting, then start looking at your
configs. Otherwise, you probably just have fairly steady data flows.

Neil

-----Original Message-----
From: David E. Mazza <dmazza at adt.com>
To: Mrtg List <mrtg at list.ee.ethz.ch>
Date: Tuesday, October 26, 1999 3:56 PM
Subject: [mrtg] New Install on Linux


>I installed MRTG 2.8.8 on RH Linux 6.1.  Everthing appears to  be
working
>except that the graphs all show little or no variance in the data
rates.
>The max average and current are all the same.  This is the same case
for
>three different routers with different configs.
>
>I'm new to MRTG and there is probably something simple that I'm doing
wrong,
>but I can't seem to figure it out.  Has anybody seen this??
>
>Thanks for any/all help!
>
>~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>  David E. Mazza
>  ADT IT Dept., WAN group
>  Phone 561.988.3864
>  Pager - 1.888.487.7125
>  Pager Email 8884877125 at page.metrocall.com
>~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>This correspondence may contain confidential information intended for
the
>use of the individual or entity to which it is addressed. If the reader
of
>this electronic message is not the intended recipient, or the employee
or
>agent responsible to deliver it to the intended recipient, you are
hereby
>notified that any dissemination, distribution or copying is strictly
>prohibited.
>
>
>


--
* To unsubscribe from the mrtg mailing list, send a message with the
  subject: unsubscribe to mrtg-request at list.ee.ethz.ch
* The mailing list archive is at http://www.ee.ethz.ch/~slist/mrtg


More information about the mrtg mailing list