[mrtg] CPU Temp and Processor Load on Cisco 3640

Jim Wurster jwurster at maverix.net
Fri Aug 11 16:08:34 MEST 2000

	I am trying to learn how to custom set up the config file for CPU, Temp and
Process. I have loaded the Cisco.proccess.mib.my in my mrtg.cfg file but how
do I figure out how to call the target? Can you specify the mib files when
running cfgmaker? If so how.

Little on my system.
	MRTG= 2.8.12
	SNMP= enable envmon (which should be the CPU/Temp/Load - Correct?)

I think I am either a going at this all wrong or b close but not finishing
something correct.

Sorry if this is a basic question, Just trying to learn.

Jim Wurster                                       jwurster at maverix.net
Team Maverix                                          Maverix.net Inc.
http://www.maverix.net/                                   312-224-3117

Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

More information about the mrtg mailing list