[mrtg] Changing Cisco interfaces

[Mike Wilker]

When I run cfgmaker on my cisco routers, it finds the subinterfaces just
fine.  The only problem I have is in the .cfg file it names each interface
1, 2, 3, etc. and when a new interface is added that changes the numbering
and therefore my graphs are wrong.  Is there a way around this?  Is it
possible to use an OID of the specific interface instead of simply calling
the 8th interface "8"?  Thanks.

Mike Wilker
Director of Network Operations
Local Link USA & Protocol Communications



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi