[mrtg] Re: Changing Cisco interfaces

[William Schwartz]

There is an option (I know it exists in the beta release) that will allow
you to build your cfg files with IP address instead of interface number.

will


-----Original Message-----
From: mrtg-bounce at list.ee.ethz.ch [mailto:mrtg-bounce at list.ee.ethz.ch]On
Behalf Of Mike Wilker
Sent: Tuesday, August 15, 2000 4:00 PM
To: mrtg at list.ee.ethz.ch
Subject: [mrtg] Changing Cisco interfaces



When I run cfgmaker on my cisco routers, it finds the subinterfaces just
fine.  The only problem I have is in the .cfg file it names each interface
1, 2, 3, etc. and when a new interface is added that changes the numbering
and therefore my graphs are wrong.  Is there a way around this?  Is it
possible to use an OID of the specific interface instead of simply calling
the 8th interface "8"?  Thanks.

Mike Wilker
Director of Network Operations
Local Link USA & Protocol Communications



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi