[mrtg] Configuring MRTG for an Intel Express 460T Stand Alone Switch

[Len Burns]

Hi,

I am wanting to configure MRTG to measure bandwidth on the ports of an
Intel Express 460T Stand Alone Switch, as well as its total throughput
to the net.  I ran cfgmaker which created a normal looking
configuration file, it showed accurately the speeds of the various
ports, but when I run MRTG against this configuration at 5 minute
intervals, the measurements look very low in comparison with other
information such as MRTG measurements on a machine attached to the
switch.  I know from this that one machine is averaging between 90 and
100 kilobytes per second, but this is not reflected on the
measurements from its port.  I am sure I am missing something here,
but not sure what it is?  Any enlightment?  TIA

-Len

--
Len Burns,
Site Engineer for Sasquatch Computer
lenb at sasquatch.com
Voice: 831-420-1053
Fax: 831-420-0468

Murphy's Eighth Law: If everything seems to be going well, you have
obviously overlooked something.



--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org