[mrtg] Re: Catalyst 2900, pulls blatantly wrong data

[Chairman of the Bored]

At 02:18 PM 9/13/2000 -0700, you wrote:
>
>On Wed, 13 Sep 2000, Steve Creel wrote:
>
>> 
>> I've got a Cisco Catalyst 2900 switch, and a few ports on it fail to show
>> any traffic that is actually moving through the ports.  It will constantly
>> show 280 bits/second (actually fluxes from 280 to like 279, but
>> anyway...).  I did a "clear counters" for that interface on the switch,
>> and presto - traffic shows up properly.  Then, like 6 minutes later or
>> something [mrtg runs on 2 min. intervals], it stopped again.  I did a
>> clear counters again, boom, there it goes, and then reverts back to
>> 280bits/sec...  The Catalyst shows proper information when you do a show
>> int [or atleast as far as I can tell].  Anyone have any ideas?  All of the
>> devices on this unit do the same thing.
>
>I have the problem with my old Catalyst 2900-XL.  The new ones that I
>purchased late last year work fine.  Unfortunately, I haven't had time to
>figure out what needs to be done to the old units so that I can upgrade to
>the new firmware.

http://www.L7.net/statistics.html

I - XX IV are all a 2924xlen switch.
-dd

                                \\\\\//                                    
       \\|//       _\\|//_      |     |      _\\|//_       \\|//           
       (@ @)      (' 0-0 ')     (.) (.)     (' @-@ ')      (o-o)           
+-=oOOo-(_)-oOOo=oo0=(_)=0oo=oOO=-(_)-=OOo=oo0=(_)=0oo=oOOo-(_)-oOOo=-+    
                | Level Seven inc. http://www.L7.net/ |                 /"\
   The worlds "one stop" InterNetworking Provider 1 (360) 753 - 3556    \ /
+-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-+  X 
ASCII Ribbon campaign against HTML E-Mail >- - - - - - - - - - - - - -> / \ 

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi