[mrtg] Re: Catalyst 2900, pulls blatently wrong data

[Steve Creel]

For anyone else who may have this problem:

Turns out that after upgrading to 11.2(8)SA6, it works great.

---------------------------------------------------------------------

On Wed, 13 Sep 2000, Daniel J McDonald wrote:

>How old is the code?  There were problems with the SNMP agent on the 
>2924XL when it first came out.

On Wed, 13 Sep 2000, Steve Creel wrote:

>I've got a Cisco Catalyst 2900 switch, and a few ports on it fail to show
>any traffic that is actually moving through the ports.  It will constantly
>show 280 bits/second (actually fluxes from 280 to like 279, but
>anyway...).  I did a "clear counters" for that interface on the switch,
>and presto - traffic shows up properly.  Then, like 6 minutes later or
>something [mrtg runs on 2 min. intervals], it stopped again.  I did a
>clear counters again, boom, there it goes, and then reverts back to
>280bits/sec...  The Catalyst shows proper information when you do a show
>int [or atleast as far as I can tell].  Anyone have any ideas?  All of the
>devices on this unit do the same thing.

___________________________________________________________
Steve Creel                           Nothin But Net, LLC.
                                      screel at nothinbut.net

"Always do right.  This will gratify some people and 
astonish the rest."
		-- Mark Twain






--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi