[mrtg] Re: MRTG and PacketShaper.

[Paul C. Williamson]

Since the error doesn't correspond to the config, I'm not sure what 
to tell you.  The error complains about  ip address 195.14.153.202,
yet that is not in your config.  Do you have more than one config 
file?

Paul

>>> "MRTG" <MRTG at Diabelec.com> 10/17/01 06:10AM >>>

Here is my mrtg.cfg file:

WorkDir: H:\InetPub\wwwroot\Mrtg
Directory[Link]: Link
Options[Link]: bits
RunAsDaemon: Yes
Interval: 5

Target[Link]:
1.3.6.1.4.1.2334.2.1.4.2.1.37.1&1.3.6.1.4.1.2334.2.1.4.2.1.37.2:Public at 192.1 
68.25.254
SetEnv[Link]: MRTG_INT_IP="192.168.25.254" MRTG_INT_DESCR="Link Traffic"
MaxBytes[Link]: 256000
Title[Link]: Link Traffic
PageTop[Link]: <H1>Link Traffic</H1>
 <TABLE>
   <TR><TD>System:</TD>     <TD>192.168.25.254.</TD></TR>
   <TR><TD>Maintainer:</TD> <TD>Technical Manager.</TD></TR>
   <TR><TD>Description:</TD><TD>Inbound/Outbound Traffic.</TD></TR>
   <TR><TD>Max Speed:</TD>  <TD>256-Kbits/s</TD></TR>
 </TABLE>

I am in Windows environment, and MRTG runs as a service using FireDaemon.

>>> "MRTG" <MRTG at Diabelec.com> 10/12/01 02:37AM >>>
Paul,

Thank you for the tips. Based on what your suggestions, we are making
progress, but we are not quite there yet.

We have corrected the OIDs to two per graph with an & in between, MRTG does
not seem to complain about that aspect any more, the error message now reads
as copied below:

The name specified is not recognized as an
internal or external command, operable program or batch file.
WARNING: rateup died from Signal 0
 with Exit Value 1 when doing router '195.14.153.202_1'
 Signal was 0, Returncode was 1
The name specified is not recognized as an
internal or external command, operable program or batch file.
WARNING: rateup died from Signal 0
 with Exit Value 1 when doing router '195.14.153.202_2'
 Signal was 0, Returncode was 1

Other than putting two (valid) OIDs per graph and removing the loadmibs
commands, the mrtg.cfg file is essentially unchanged.

What could be causing the above error messages?

Thank you for your assistance.

George Jahchan


--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi