[mrtg] Re: cfgmaker and VRRP/HSRP?

[Stefano Giraldo]

U could monitor the interfaces on their real IP address, 
'n then use the aggregate traffic analysis [target] 1st_int + 2nd_int. 
So it should work. 
Only a suggestion... the mrtg server should be on the same IP LAN 
(or VLAN) of the routers dued to routing problems that can occur.

Bye, 

        Ste.

----- Original Message ----- 
From: "Mordechai T. Abzug" <morty at frakir.org>
To: <mrtg at list.ee.ethz.ch>
Sent: Friday, August 20, 2004 9:18 AM
Subject: [mrtg] cfgmaker and VRRP/HSRP?


> 
> Is there any way to get MRTG's cfgmaker to skip VRRP and/or HSRP
> interfaces?  We tend to set up VRRP/HSRP with a "real" IP for each
> device and an extra IP held by the current "live" device.  When I run
> cfgmaker with --ifref=ip, often, the "virtual" IP is picked on the
> currently live device instead of the real one, and the real one is
> skipped because of the underlying interface instance is the same.
> This means that in the event of a failover, the config is wrong.  I've
> been fixing the config manually; is there a better way?
> 
> Thanks!
> 
> - Morty
> 
> --
> Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
> Archive     http://www.ee.ethz.ch/~slist/mrtg
> FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
> WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi
> 
> 

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi