[mrtg] mrtg newbie

[Oswin Budiman]

i'm trying to configure mrtg for broadband router (DLink 740P) which act as internet gateway for about 15 people in the network. I've followed the manual, but it still couldn't set up well. i run the following command:

- perl cfgmaker public at 192.168.1.1 --global "WorkDir: c:\www\" --output router.cfg
- perl mrtg router.cfg

and the content of router.cfg output is as follow,
-------------------------------------------

# Created by 
# cfgmaker public at 192.168.1.1 --global 'WorkDir: c:\www\mrtg' --output router.cfg


### Global Config Options

#  for UNIX
# WorkDir: /home/http/mrtg

#  or for NT
# WorkDir: c:\mrtgdata

### Global Defaults

#  to get bits instead of bytes and graphs growing to the right
# Options[_]: growright, bits

EnableIPv6: no

######################################################################
# System: 
# Description: Internet Gateway Device
# Contact: 
# Location: 
######################################################################


### Interface 1 >> Descr: 'Ethernet-WAN' | Name: '' | Ip: '' | Eth: '00-0d-88-00-79-f5' ###
### The following interface is commented out because:
### * has a speed of 0 which makes no sense
# 
# Target[192.168.1.1_1]: 1:public at 192.168.1.1:
# SetEnv[192.168.1.1_1]: MRTG_INT_IP="" MRTG_INT_DESCR="Ethernet-WAN"
# MaxBytes[192.168.1.1_1]: 0
# Title[192.168.1.1_1]: Traffic Analysis for 1 -- 
# PageTop[192.168.1.1_1]: <H1>Traffic Analysis for 1 -- </H1>
#  <TABLE>
#    <TR><TD>System:</TD>     <TD> in </TD></TR>
#    <TR><TD>Maintainer:</TD> <TD></TD></TR>
#    <TR><TD>Description:</TD><TD>Ethernet-WAN  </TD></TR>
#    <TR><TD>ifType:</TD>     <TD>ethernetCsmacd (6)</TD></TR>
#    <TR><TD>ifName:</TD>     <TD></TD></TR>
#    <TR><TD>Max Speed:</TD>  <TD>0.0 Bytes/s</TD></TR>
#  </TABLE>


WorkDir: c:\www\mrtg

-----------------------------------------------

but I couldn't find any output result in c:\www\mrtg folder! not even a single file...

FYI, the router IP is 192.168.1.1 and it has snmp v1. The get community string is public. i'm using winXP.
As for now i've been using prtg freeware edition, and it works well. but i want 2 use mrtg for the traffic report. 
Does anyone know what the problem is?

n btw, can i make the bandwith graphic for each IP in my network? So i can know every traffic from every IP in my network. Or is there any tools that can do that? 

Thx in advance.

BR,


"How can one knows the best if one hasn't experience the worst yet?"

-- 
___________________________________________________________
Sign-up for Ads Free at Mail.com
http://promo.mail.com/adsfreejump.htm

--
Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi