[mrtg] Re: HELP - MRTG not reading the T1 Interface of an Ascend Pipeline 130

Alex van den Bogaerdt alex at ergens.op.het.net
Wed Oct 13 16:53:20 MEST 2004

On Wed, Oct 13, 2004 at 07:37:48AM -0700, Travis Rabe wrote:

> 17channels = 1.0936Mbs.  If I convert that I get:
> 1.0936 megabits
> bits	1146722.7136
> bytes	143340.3392
> kilobits	1119.8464
> kilobytes	139.9808
> megabits	1.0936
> megabytes	0.1367
> gigabits	0.00106796875
> gigabytes	0.00013349609375

giga = 1000 mega, mega = 1000 kilo, kilo = 1000.

Forget about 1024. Using 1000 has the added benefit of being
able to just shift the decimal point ...

>                                                               *BUT* it also
> tells me that my T1 interface has a max speed of 7000bytes/second, but that
> is WAY OFF.

cfgmaker uses what is reported by the device.  Perhaps it does report
another number on the cmdline but it is SNMP what counts.

You can edit the config file by hand if you like, or fix the device.

You want an answer?  You'd better follow the following guidelines!
Linesize well below 80 chars. Reply to the list, not to me. Trim
irrelevant lines. Answer below the remaining paragraph.

Unsubscribe mailto:mrtg-request at list.ee.ethz.ch?subject=unsubscribe
Archive     http://www.ee.ethz.ch/~slist/mrtg
FAQ         http://faq.mrtg.org    Homepage     http://www.mrtg.org
WebAdmin    http://www.ee.ethz.ch/~slist/lsg2.cgi

More information about the mrtg mailing list