[mrtg] Need to graph protocol numbers.

[Mersberger, Robert]

 You need something other than MRTG to do this.  Something like netflow
or even a good sniffer will breakdown the protocols but to my knowledge
the protocols are not a mib variable.

If you can not see it in the results of an snmpwalk it is not there.

Good luck.


-----Original Message-----
From: mrtg-bounces at lists.oetiker.ch
[mailto:mrtg-bounces at lists.oetiker.ch] On Behalf Of
Edward_Kenna at haygroup.com
Sent: Thursday, February 15, 2007 1:06 PM
To: mrtg at lists.oetiker.ch
Subject: [mrtg] Need to graph protocol numbers.


I have been tasked with finding a way to graph in MRTG in and out bytes
for different IP protocols. Right now I am testing with a Nortel
Contivity 1600 but I will also need to do the same for a CISCO switch.
Ideally there would be a graph for each protocol ie HTTP, VOIP, SMTP,
etc.

I realize I need to create a target for each protocol something along
the lines of

Target[x.x.x.x_1]: oid&oid:public at x.x.x.x:

where x.x.x.x represents and IP address and oid represents some number
in this format 1.3.6.1.

The only problem at this point is finding what oid holds the byte count
for each protocol. I think this should be listed in a MIB somewhere
however I have not been able to find it. I have been out to the nortel
site and not been able to find anything like this.

Has anyone done anything like this? Can anyone point me to the correct
information?


(Embedded image moved to file: pic09894.gif)


CONFIDENTIAL NOTICE:
This e-mail message and any attachment(s) (collectively, this 'Email') are intended
only for the confidential use of the recipient(s) named above. If the reader of this
message is not the intended recipient named above or an agent responsible for
delivering it to the intended recipient named above, you have received this Email in error.
Please notify the sender immediately and permanently delete this Email and any copies thereof.