[rrd-users] update not on a 5 minute boundary

[George Dau]

Ok, I have read and understand the issues for changing the timestame to be a
multiple of 60 in order to generate integers when measuring integer data. I
can do this for about a fifth of my data, but because of the volume of data
(over 50,000 OIDs) I can't run them all at 0,5,10,15,20 etc. I have to
spread them out and run some at 1,6,11,16,21 and some at 2,7 and so on over
the 5 minutes or everything locks up on i/o wait and will not finish in 5
minutes. If I split them up they do finish in 5 minutes.

rrdtool saves the data internally on 5 minute boudaries, which is fine, but
can I change the off-sets for data collected on other minutes, other than
0,5,10,15,20 etc.


**************************************************************
The information contained in this E-Mail is confidential
and is intended only for the use of the addressee(s).
If you receive this E-Mail in error, any use, distribution
or copying of this E-Mail is not permitted.  You are 
requested to forward unwanted E-Mail and address any problems
to the MIM Holdings Limited Support Centre. 
E-Mail: supportcentre at mim.com.au or phone: Australia 07 3833 8042.
**************************************************************